Bmeters MB-PULSE 4 Pulse

Bmeters MB-PULSE 4 Pulse

Bmeters MB-PULSE 4 Pulse module allows to convert the classic impulse signal (REED or OC) to the Wired M-BUS standard (EN13757-3). It is possible to connect up to four pulse meters (water, gas, electricity, heat etc), any caliber, any manufacturer and any version.

Each record is distinguished by four separate addresses, allowing easy reading of the consumptions. Easy installation and configuration. It is possible to configure the primary addresses by using the B METERS software BMBUS and master mod.MB-MASTER.

     Another Article:

Bmeters MB-PULSE Technical Features

DIMENSIONS 89 x 74 x 40 mm
WEIGHT 122 g
TEMPERATURE RANGE +1° / +55°C
POWER SUPPLY From BUS Network, 3 V Lithium Battery (backup)
BATTERY LIFE 1 year (if disconnected from BUS network)
PROTECTION CLASS IP65
TRANSMISSION PROTOCOL MBUS Standard EN 13757-3
MEASUREMENT SENSIBILITY 1 – 10 – 100 – 1000
MEASUREMENT UNITS AVAILABLE L – Wh – KJ
TRANSMITTED DATA Consumption Device Status
INPUTS N°4 pulse inputs. Connectable to pulse emitters (REED and Open Collector)
MAXIMUM INPUT FREQUENCY 20 Hz
OUTPUT N°1 Wired MBUS output

Download Datasheet: Bmeters MB-PULSE 4 Pulse to Wired M-Bus signal converting module

Reference: bmeters.com

Share
%d bloggers like this: