EFS-T Energoflow-Reference Turbine Gas Meters

Reference Turbine Gas Meters EFS-T Energoflow
Reference Turbine Gas Meters EFS-T Energoflow
Reference Turbine Gas Meters EFS-T is intended for installation on reference calibration rigs for calibration and verification of gas meters of any type with air as the operating environment. The meters are equipped with an electronics unit (EU) and rotary transducer with mounted binary pulse-frequency sensors and pressure sensors.
The meter EFS-T is intended for measuring the volume of gas passing through its input channel of circular section. The gas flow volume is transmitted to a PC via the EU. The meters are designed for vertical installation on the reference equipment with DN 50 mm, DN 80 mm, DN 100 mm, DN 150 mm, DN 200 mm, DN 250 mm, DN 300 mm, DN 400 mm.

Technical Data

Parameters Value
General industrial application design Explosion-proof design
Measuring medium air
Operating pressure, MPa 1,6; 4,0; 6,3
Limits of basic relative permissible error,
not worse %
± 0,2
Repetition, at least % ± 0,03
Repeating accuracy within 2 years, at least % ± 0,1
Frequency output with adjusted multiplication factor Fmax, kHz 5
Signal of flow rate excess for the emergency system shutdown Type «dry contact»
Loading capacitance of emergency output shutdown:
voltage, V, max
max current, mA, max
24
20
Operating conditions:
-The temperature of the operating environment and ambient air, °C, at least
– Relative humidity of air at the temperature
+25 °C, %
– atmospheric pressure, kPa
10 up to 30

up to 80
from 84,0 up to 106,7

Power consumption, W, max 0,5 6,0
Supply voltage, DCV from 9 up to 24
Lifetime, min. years 10

 

     Another Article:

Archive data: 

  • hourly- for every preceding hour – the size of archive 1488 records (62 days);
  • daily- for every preceding day – the size of archive 730 records;
  • power on/off instances – the size of archive 512 messages;
  • emergencies – the size of archive 720 messages;
  • intervention – changing the adjustment parameters (size of archive 889 messages).

The control software program is used for recording, viewing, and changing the settings of the flow meter, recording, and viewing of measurement data, as well as for reading data archive.

This program allows you to view the archive data and modify the flow meter settings via a PC monitor and then upload the archive data to a file on the flow meter. The flow meter protects settings and archive data from unauthorized changes by restricting access through a system of passwords and hardware-based protection of configuration from being overwritten.

Download Catalog: ULTRASONIC GAS FLOW METERS
Ref: Energoflow.com