Flocorp PDFlo™ PDSR1 and PDSR2 is a dual hall effect sensor that is compatible with PDFlo Positive Displacement Spur Gear Flow Meters. This microprocessor-based sensor can detect both uni- and bi-directional flow. The sensors’ mode of operation is determined by an output selection switch located inside the housing. The PDSR2 detects the rotation of the flow meter’s gears and emits a frequency signal proportional to flow. The output signal is a square wave pulse which has a duty cycle of approximately 50%.
The signal outputs are protected with a self-resetting fuse. This fuse has a 50mA nominal trip point. When a trip occurs, turn off power to the sensor and remove the output load to reset fuse. The PDSR2 is supplied with a sinking (non-powered) output or a sourcing (powered) frequency output.
Another Article: |
Specifications
PDSR1 Spur Gear Flow Meters
| Supply Voltage | + 10 to 28 VDC |
| Supply Current | 8mA@ 12VDC, 12mA @ 24 VDC |
| Duty Signal | 50% ± 15% |
| Minimum Signal | 0.5 Hz |
| Frequency Output | Flow dependent, up to 2,000 Hz |
| Driving Capacity | 50mA Max resistive load |
| Output Impedance | ~ 40 Ohm – analog switch and self- resetting fuse |
| Temperature Range | -40ºF to 185ºF (-40º to 85ºC) |
| Classification | General Purpose: PDSR1- -GP; Explosion Proof: PDSR1- -XP |
PDSR2 Spur Gear Flow Meters
| Supply Voltage | + 10 to 27 VDC |
| Supply Current | 18mA@ 12VDC, 25mA @ 24 VDC |
| Duty Signal | 50% ± 15% |
| Minimum Signal | 0.5 Hz |
| Frequency Output | Flow dependent, up to 2,000 Hz |
| Driving Capacity | 50mA Max resistive load |
| Output Impedance | ~ 40 Ohm – analog switch and self- resetting fuse |
| Temperature Range | -40ºF to 185ºF (-40º to 85ºC) |
Download Datasheet: PDFlo™ PDSR1 & PDSR2, Flocorp-Spur Gear Sensor
Ref: FLo-corp.com