Portable Ultrasonic Flow Meter TDS-100H is designed to measure the fluid velocity of liquid within a closed conduit. The transducers are a non-contacting, clamp-on type, which will provide benefits of non-fouling operation and easy installation.
Portable Ultrasonic Flow Meter TDS-100 transit time flow meter utilizes two transducers that function as both ultrasonic transmitters and receivers. The transducers are clamped on the outside of a closed pipe at a specific distance from each other.
The ultrasonic transducers can be mounted in V-method where the sound transverses the pipe twice, or W-method where the sound transverses the pipe four times, or in Z-method where the transducers are mounted on opposite sides of the pipe and the sound crosses the pipe once. This selection of the mounting method depends on pipe and liquid characteristics.
Portable Ultrasonic Flow Meter TDS-100H operates by alternately transmitting and receiving a frequency modulated burst of sound energy between the two transducers and measuring the transit time that it takes for sound to travel between the two transducers. The difference in the transit time measured is directly and exactly related to the velocity of the liquid in the pipe
Portable Ultrasonic Flow Meter TDS-100H s is based on a clamp-on transit-time flow measurement principle. It measures the flow rate of liquid in a pipe from the outside of the pipe by using a pair of ultrasonic transducers. In general, the liquid should be full in the pipe and should contain very little particles or bubbles.
|Accuracy||: ±1% of reading at rates>0.2 MPs|
|Response Time||: 0-999 seconds, user-configurable|
|Velocity||: ±32 m/s|
|Pipe Size||: 20mm-6000mm|
|Rate Units||: Meter, Feet, Cubic Meter, Liter, Cubic Feet, USA Gallon, Imperial Gallon, Oil Barrel, USA Liquid Barrel, Imperial Liquid Barrel, Million USA Gallons. User-configurable.|
|Totalizer||: 7-digit totals for net, positive and negative flow respectively|
|Liquid Types||: Virtually all liquids|
|Security||: Setup values Modification Lockout. Access code needs unlocking|
|Display||: 4×16 English letters|
|Communication Interface||: RS-232C, baud-rate: from 75 to 57600. Protocol made by the manufacturer and compatible with that of the FUJI ultrasonic flow meter. User protocols can be made on inquiry.|
|Transducers||: Model M1 for standard, other 3 models for optional|
|Transducer Cord Length||: Standard 2×10 meters, optional 2x 500 meters|
|Power Supply||: 3 AAA Ni-H built-in batteries. When fully recharged it will last over 10 hours of operation.100V-240VAC for the charger|
|Data Logger||: Built-in data logger can store over 2000 lines of data|
|Manual Totalizer||: 7-digit press-key-to-go totalizer for calibration|
|Housing Material||: ABS|
|Case Size||: 100x66x20mm|
|Handset Weight||: 514g (1.2 lbs) with batteries|