Descriptions
Oeltechnik Shell & tube heat exchanger. OELTECHNIK has developed, tested and continuously improved its shell & tube product program in response to the challenges of the industry. The in-house developed software is based on recognized literature such as VDI Wärmeatlas and HEI. It has been checked against actual test performance of our equipment.
OELTECNIK has always taken challenges to explore further design options for shell & tube heat exchangers. Shell & tube heat exchangers are rated, designed and fabricated in-house and can be supplied according to individual customer’s specifications.
Design parameters
OELTECHNIK’s products are successfully in use worldwide. Our design and fabrication capabilities are covering all international design codes and national regulations.
Our type OK coolers are standardized from 100 mm (4”) to 400 mm (16”) in shell diameter. Typically, oil is on the shell side and water on the tube side. For every application the coolers are individually check-rated with our thermal rating programs. For higher flow rates custom tailored designs are prevailing. Certainly, the OK type shell & tube heat exchanger can be used for other liquid to liquid applications.
The type LK indicates that one fluid is gaseous or has major gas components. Together with our customer we decide whether the gaseous fluid is on shell or tube side. Factors like design pressure, desired nozzle location, aggressiveness of fluids, desired material combination, thermal performance and allowable pressure drop influence the decision about fluid location.
OELTECHNIK will assist you in making the most economical selection under consideration and evaluation of all parameters.
Capabilities / Range of application:
| Design pressure: | 2 – 250 barg | 29 – 3625 psig |
| Design temperature: | -25 – 350 °C | -13 – 662 °F |
| Shell diameter: | 80 – 4000 mm | 3 – 157 inch |
| Maximum weight: | 100 t |
Typical fluids:
| Shell side: | Oil, water, glycol, water glycol solutions, other liquids, wet gases with separators |
| Tube side: | Water, glycol, water glycol solutions, dry gases under high pressure, wet gases with separator in down-stream |
Material combinations:
| Tubes: | Bare tubes or low-fin tubes made of: 90/10 CuNi, 70/30 CuNi, Admirality, 304 SS, 316 SS, Duplex, Super Duplex, Titanium and all other commercial available materials |
| Tube sheets: | Carbon steel, 90/10 CuNi, 70/30 CuNi, solid, cladded, CuZn 38 SnAl, Stainless steel, Duplex, Titanium, and all other commercial available plate materials |
| Channels: | Carbon steel, Stainless steel, castings in iron and copper alloys |
| Shell side: | Carbon steel, Stainless steel |
TEMA:
OELTECHNIK designs and fabricates shell and tube heat exchangers according to the recommended good manufacturing practice of TEMA (Standard of the Tubular Heat Exchanger Manufacturing Association).
Download : Datasheet
Another Article:
- OELTECHNIK Logistical System and Spare Parts
- Brand and Parts List Manufactures
- OELTECHNIK Logistical System and Spare Parts
- Oeltechnik Oil System
- Oeltechnik Shell & tube heat exchangers
- Onicon System-20 BTU Meter
- Oeltechnik Element coolers
- Kofloc 6800 Series Back Pressure Valve