West Control Solution Powerstack 3PH Thyristor Power Controller:
West Control Solution Powerstack 3PH Thyristor Power Controller:

West Control Solution Powerstack 3PH Thyristor Power Controller

West Control Solution Powerstack 3PH Thyristor Power Controller

These thyristor units are ideal for 3 phase configuration with neutral connection, normal (Relay S or Relay M) or variable resistive loads and transformer load types (PM3000-3PH). Relay S- 3PH = Simple on/off firing with a DC logic input, time proportioned burst firing with a DC linear input (basic firing selectable between 4,8 or 16 cycles) Relay M – 3PH = Time proportioned burst firing with a DC linear input (fully adjustable burst firing (3 to 255 cycles)), front panel display & keypad plus RS485 comms as standard. West Control Solutions presents a range of thyristor power controllers which have been designed to switch 3 legs of 3 phase loads.

West Control Solution Powerstack 3PH Thyristor Power Controller
West Control Solution Powerstack 3PH Thyristor Power Controller

Descriptions of West Control Solution Powerstack 3PH Thyristor Power Controller

PMA3000 – 3PH = More complex load requirements that may need phase angle firing, delayed triggering, or features such as feedback, current limit etc.

Benefits & Features West Control Solution Powerstack 3PH Thyristor Power Controller:

  • Suitable to drive resistive, inductive, transformer with normal resistor
  • Two legs switching three wires loads STAR or DELTA connection
  • Frontal Key Pad standard to configure all the internal functions and
  • parameters.
  • Four Analog output configuirable
  • Six Digital input
  • Four realay output
  • Universal Input signal with automatic zero/span calibration.
  • Universal Firing modes, customer configurable via Key Pad or
  • communication port as Burst Firing or Delayed Triggering
  • Universal Feed back modes
  • Soft Start can be used in addition to Burst Firing and Phase Angle.
  • Unbalanced load and Heater Break Alarm.
  • RS 485 port. Modbus protocol
  • Comply with EMC
  • IP20 Protection

Specification West Control Solution Powerstack 3PH Thyristor Power Controller:

  • Up to 2700A
  • 3, 4 & 6 wire
  • 24Vac to 690Vac Supply
  • 4-20mA or 0-10V DC linear inputs
  • 10K Pot or RS485 Comms input
  • Burst Firing
  • Single Cycle
  • Soft Start + Burst Firing
  • Delayed Triggering + Burst Firing
  • Phase Angle
  • Soft Start + Phase Angle

Source : www.west-cs.co.uk

Read More Articles :

Similar Posts