Eurosens DPS converts the air pressure in the output voltage or digital messages via serial RS485 or automotive CAN bus J1939 protocol. As the pressure transducer thin-film bridge is used.
Eurosens DPS A output:
| Pressure, Mpa | Output voltage, V |
| 0 | 0,25 |
| 0,1 | 0,70 |
| 0,2 | 1,20 |
| 0,3 | 1,55 |
| 0,4 | 2,00 |
| 0,5 | 2,50 |
| 0,6 | 2,95 |
| 0,7 | 3,30 |
| 0,8 | 3,80 |
Eurosens DPS RS uses LLS/MODBUS protocol
Eurosens DPS CAN uses CAN bus J1939 protocol with configurable PGN.
After installation and wiring Eurosens DPS should perform a calibration in which you are mapping the output signal to the load on the suspension of the vehicle.
Read more article:
- Delphin Technology Expert Logger
- Deep Sea Electronic DSEE050 Engine Display and Controller
- B+B SmartWorx SmartStart™ Smart Hardware
- Fluidwell D490 Indicator untuk Berbagai Aplikasi Peralatan Instrument
- ACR Artex C-Light Manual Activated Personal Distress Light