Flow Meter Group FMT-DC Turbine Gas Meter is a unique meter, designed to perform on the highest level of accuracy. The meters comply with all international standards and are approved for custody transfer. The actual flow sensor, TWO cartridges which are exchangeable with conventional cartridges used in other turbine meter series, can monitor all kinds of flow effects and monitor the results if connected to flow computer devices.
Since these flow computer can analyze any effect, the FMT-Dc is also able to monitor itself and detect any kinds of failures. For example bearing failures, blade failures of dirt in the meter. When in use, the two independent turbine wheels are not subjected simultaneously to the same flow effects.
This results in minimal differences between the two turbine wheels, which are being detected and diagnosed by the flow computer in a split second. This technique allows for a significant reduction in the uncertainty margin. Also, it opens new possibilities for the future, e.g. remote calibration could be a next step in successfully reducing the measurement uncertainty.
To fully exploit the possibilities of two turbine wheels, it has to be established that both turbine wheels operate independently and that occurring influences do not have the same effect at the same time on both turbine wheels.
Flow Meter Group FMT-DC Turbine Gas Meter Principle
The operation of the FMT series of turbine meter is based on the measurement of the velocity of the gas. The flowing gas is accelerated and conditioned by the integrated multi-stage flow conditioner. The multi-stage flow conditioner prepares the gas flow profile by removing undesirable swirl and asymmetry before the gas flows over the freely rotating turbine wheel.
The dynamic forces of the flowing gas cause the rotor to rotate. The turbine wheel is mounted on the main shaft, with high-precision, low-friction ball bearings. The turbine wheel has helical blades that have a known angle relative to the gas flow. The gas flow drives the turbine wheel at an angular velocity, which is proportional to the gas velocity. Using a gearing mechanism, the rotating turbine wheel drives the mechanical counter.
The standard FMT-Lx turbine meter is suitable for custody transfer gas measurement of all non-corrosive gases such as natural gas, propane, butane, air, nitrogen, hydrogen, etc. for low and high operating pressures. The special construction of the FMT-Dc enables us to meet the performance of the FMT-Lx, but can provide twice the amount of information. The FMT-Dc can be modified to perform as a master meter or transfer master meter.
Flow Meter Group FMT-DC Main Features
- Flow range 10 – 40.000 m3/h
- Diameters DN80 – DN600 (3” – 24”)
- Pressure rates PN 10 – 100, ANSI 150 – 600
- Compliant with MID 2014/32/EU
- Compliant with OIML R137 1&2 (2014)
- MID temperature range -40ºC to +70ºC
- Length 3 x DN
- Removable meter cartridge
- 2 x DN inlet/outlet sections required
- Oil flushing and lubrication system
- Multipurpose exchangeable index
- Tamper-proof IP67 sealed index
- 1 FMT-Dc is similar to 2 FMT-Lx meters
- Seals according to EN 549 (seals for gas appliances and gas equipment)
Download Catalog: FMT-Dc Turbine Gas Meter Flow Meter Group