Plugs & Jacks T-Series SwitchPlug, Connector-Amphenol

T Series plug and jack Amphenol
T Series plug and jack Amphenol

The Amphenol T series SwitchPlug uses a unique 360-degree precision sliding helical spring contact design to quietly and accurately switch the signal circuit safely to the ground during instrument changes under load, thereby avoiding annoying thumps, pops and squeals. The sliding ring contact self-cleans every time the plug is connected preventing an excessive build-up of oxidization and contamination. Activation is directly off the jack’s full front face assuring a positive reference point every time, and as it works instantaneously on the main circuits there is no need for the use of magnets or other elaborate switching mechanisms.

Another Article:

Specifications:

VALUE
Straight Right Angle Jumbo
GENERAL CHARACTERISTICS Number of Contacts 3 Pole Tip Ring Sleeve (Stereo)
Termination Solder
Max. Wire Gauge – Stranded Wire 3 Pole (Stereo): AWG 18˜1mm
Flammability rating of insulating plastics UL94V-0
Solderability complies with IEC 68-2-20
Environmental Complies with EU RoHS 2 Directive 2011/65/EU
ELECTRICAL CHARACTERISTICS Current Carrying Capacity 10A (Depends on Mating Connector and Cable)
Typical Contact Resistance Depends on Mating Connector
Insulation Resistance (initial) >2GΩ
After Damp Heat Test ≥1GΩ
Dielectric Withstand Voltage 2 Pole : 1.5 kV dc3 Pole : 1 kV dc
CLIMATIC CHARACTERISTICS Protection Class IP40
Operating Temperature -25°C to +75°C (-13°F to + 167°F)
MECHANICAL CHARACTERISTICS Insertion and Withdrawal Force ≥10N – ≤30N
Weight1 Thermoplastic Backshell 28g (0.061lb)
Metal Backshell 35g (0.077lb)
Typical Cable Retention Force 22kg to 44kg (50lb to 100lb) – Dependent on cable material and diameter.
Standard Jaw (T-Series) 3mm to 6mm (0.118” to 0.236”) 3mm to 5.5mm (0.118” to 0.216”) N/A
Large Jaw (T-Series) 6mm to 7mm (0.236” to 0.275”) 5.5mm to 6.5mm (0.216” to 0.255”) N/A
Cable O.D. Standard Clamp (Q-Series) 3.5mm to 7mm (0.137” to 0.275”) N/A N/A
Jumbo NA NA 7.5mm to 10.5mm (0.295” to 0.413”)
Mechanical Operations Diecast Zinc Alloy EZDA No.3
MATERIALS Connector Shell Material Satin Nickel or Black Polyester
Shell Finish UL94 V-0 PBT Resin or Modified PPE Resin – Black
Insulators UL94 V-0 PBT Resin or Modified PPE Resin – Black or Metal CuZn39Pb3
Boot / Backshell UL94 V-0 PBT Resin or Modified PPE Resin – Black or Metal CuZn39Pb3
Cable Clamp Santoprene
Cable Bushing Brass /Ni or Au over 2µm Ni
Contacts / Plating Brass /Ni or Au over 2μm Ni

Download Catalog: Amphenol Connector Catalog

Ref: Amphenol.com

Be the first to comment