Bamo CDP Paddle Flow Controller

Bamo CDP Paddle Flow Controller operates a switch outside the liquid: The flow drives the paddle. A magnet on top of paddle actuates a Reed contact, located outside the fluid. The reverse movement of the paddle is generated by a leaf-spring.

These controllers offer a simple, reliable and inexpensive solution for flow monitoring in pipelines. CDP controllers are mounted in-line, pipes up to ND 50 with a Tee, BSPF threads. For larger diameters, CDP must be mounted on-line, on an adaptor BSP ½” female thread.

Bamo CDP Paddle Flow Controller Features:

  • 1 Reed contact N.O. / N.C.
  • Stainless steel or brass versions
  • Low pressure drop
  • Fittings: On tee up to ND50 or BSP ½”

Accessories:

  • The Reed contact has a low switching power:
    The use of a relay ES 2001 (doc. 250-02) will protect the Reed and allows a remote loop signal with greater breaking capacity on a change-over relay output (500 VA/ 250 V A / 5A – 1A/ 125 V DC/ 40 W).

Application:

Detection of presence or absence of flow of a liquid in a pipe under pressure. The liquid must be free of magnetic particles.

Another Article:

Bamo CDP Paddle Flow Controller Specification:

Body AISI 316 Ti
Brass
Seal FPM on stainless steel version
NBR on brass version
Temperature limit 110 °C
Ambient temperature 70 °C
Pressure limit 25 bar
Fittings DN 10 to DN 50: Tee with BSP female threads
ND 50 and larger: male thread BSP ½”
Contact output N.O. or N.C. according the Reed contact orientation
Switching power 230 V / 1.5 A / 80 W / 90 VA max.
Output cable PVC; 3-wire; 1 mm² ; 1.5 m long
Trigger point adjustment ±15 % of table values, horizontal pipe; See next page
Protection IP 65

Download Data Sheet: Paddle Flow Controller CDP

Ref: bamo.eu

Share
%d bloggers like this: