Seametrics Multi Jet MJ-Series Water Flow SensorIndonesia Industrial Parts

Seametrics Multi Jet MJ-Series Water Flow Sensor, which has been an internationally-accepted standard for many years. This type of meter is known for its wide range, simplicity, and accuracy in low-quality water. Seametrics offers cold or hot water models.

Seametrics Multi Jet | Flow Meter Turbine

The impeller is centered in a ring of jets, with inlet jets on one level and outlet jets on another. A gear train drives the register totalizer dials. For pulse output, one of the pointers is replaced by a magnet, which is detected by an encapsulated sensor attached to the outside of the lens. Pulse rate is determined by the dial on which the magnet is placed, and by the number of sensors (single or double).

Seametrics Multi Jet Type of specification :

MJ Series – (Standart)			MJP Series -Plastic Body with NSF/ANSI standard 61			MJN Series -Brass Body with NSF/ANSI standard 61

MJE/ MJHE*	MJR/ MJHR**	MJT/ MJHT***	MJPE*	MJPR**	MJPT***	MJNE*	MJNR**	MJNT***

Note:

*-E meters use a solid-state, long-lasting Hall-effect sensor, which requires power. It is suited for use with Seametrics controls and metering pumps that have sensor power.
**-R meters use a two-wire reed switch. They provide dry contact closure and do not require power.
***-T meters totalize only and do not have a sensor
Meter names that include “H” are hot water models (MJH). Without the “H” = cold water models (MJ)

Model			-E	-R	-T
Power			6 mA at 12 Vdc	–	–
Temperature	Coldwater		105 ? F (40 ? C) max
	Hot Water		194 ? F (90 ? C) max
Pressure			150 psi operating (10.3 Bar)
Materials	Body	MJ	Cast bronze, epoxy powder coated inside and out
		MJP	Plastic
		MJN	Eco-brass alloy (MJN)
	Internals		Engineered thermoplastic
	Magnet		Alnico
Accuracy			±1.5% of reading
Pulse Output	Sensor		Hall-effect device	Reed switch	Totalizer only
	Max Current		20 mA+	20mA	n/a
	Max Voltage		24 Vdc	24 Vdc or Vac	n/a
Cable Length			12’ (4 m) standard (2000’ maximum run)

Flow Rate
	MJ- Series	3/4″	1″	1-1/2″	2″	MJN/MJP Series	3/4″	1″	1-1/2″	2″
	Minimum	0.22	0.44	0.88	1.98	Minimum	0.22	0.44	0.88	1.98
	Maximum	22	52	88	132	Maximum	22	52	88	132