Bamo CDP 57 Paddle Flow Controller

Bamo CDP 57 Paddle Flow Controller The flow of liquid drives the paddle which actuates a Reed contact via a magnet mounted on top of the paddle. The second magnet in opposition pushes back the paddle when the flow is decreasing. This design allows the controller to be mounted in any position.

Bamo CDP 57 Paddle Flow Controller Features:

For clear liquids
Stainless steel or brass versions
For pipes from ND 50 up to ND 200
Mounting on-line, fitting with loose nut BSPF ½”

Mounting precautions:

Mounting could be on a vertical pipe with ascending flow; Then, the threshold value will be greater than the one of the table. The pipe slope of a flowing down piping must be less than 40 %.

Accessories:

An amplifier relay ES 2001 protect the Reed contact and allows a switching power of up to 500 VA / 250 V AC / 5 A – 1 A / 125 V DC / 40 W).

Application:

Detection of the presence or not of flow in a pipe under pressure. The liquid must be free of magnetic particles.

Another Article:

Bamo CDP 57 Paddle Flow Controller Specification:

Materials	Body and fitting in AISI 316 Ti with FPM seals
	Body and fittings in brass with NBR seals
Fittings	Male thread BSP ½”
For pipes	From ND 50 up to ND 200 mm
Temperature limits	Liquid: -25 … 110 °C
	Ambient: -25 … 80 °C
Pressure limit	PN 25
Electrical Specifications :
Contact	N.O. or N.C. (according terminals)
Operation	Flow below the switching point: Open contact
	Flow over the switching point: Closed contact
	Possibility to reverse the logic
Current limit	Max. 1 A
Voltage limits	Max. 230 V AC, 48 V DC
Switching power	Max. 26 VA, 20 W
Switching point	± 15 % of table values
Protection	IP 65
Connector	Plug DIN EN 175301-803-A