AW-Lake FIP Analog Output Sensor

AW-Lake FIP Analog Output Sensor is a microprocessor based, meter mounted, analog output sensor. Each unit has a sensor, amplifier and converter module built into an aluminum junction box. The FIP is designed to handle frequencies up to 5,000 Hz. The operational frequency range is user defined via four BCD rotary switches, where the high flow rate in frequency is set to 20 mA, 5V or 10V, and the output signal is automatically scaled. Electrical connection options include ½” NPT for running conduit piping, 4-pin connector or 3-pin connector. For use with all JV-CG and JV-KG gear meters

AW-Lake FIP Analog Output Sensor Features:

Meter Compatibility: Used with all JV-CG and JV-KG meter
Sensor Type: Current or voltage signal output sensor
Conversion: Converts frequency to an analog output (includes sensor)
Available in six outputs: 1-5 VDC, 2-10 VDC, 4-20 mA, 0-5 VDC, 0-10 VDC, and 0-20 mA

Another Article:

AW-Lake FIP Analog Output Sensor Specification:

Supply Voltage: 10-30 VDC
Supply Current: 60 mA max
Signal Output:
- 0-20 mA, 4-20mA or
- 0-5V, 0-10V, 1-5V, 2-10V
Max Load Impedance: (Vcc/0.02) – 275 ohm (for mA out)
Min Load Impedance: 500 ohm (for Volt out)
Driving Capacity: For Voltage output only 10 mA max
Temperature Range: 0-185° F
Jumper Settings
- J1 AB:
- Analog Output
BC:
- Frequency Output
J2 AB:
- Housing Ground
CB:
- Signal ground
Response Time:
- 1/F + 25 msec
Frequency Input:
- 5 KHz max
Diagnostics:
- A glowing LED indicates the unit is working.
- The LED will blink to show an active frequency.