Bamo TP 805 Pressure Transmitter

Bamo TP 805 Pressure Transmitter Features:

Bamo TP 805 Pressure Transmitter is factory adjusted to its measuring range and can not be modified on site. It does not require maintenance.

The pressure transmitter is used for pressure measurements, continuously in real time, of gases and liquids.

Pressure ranges	0… 2.5 up to 0 … 25 barg
Overload limit:	2.5 times the full scale
Accuracy	±0.5 % F.S.
Inclusive: variations on zero point, end of range, linearity, hysteresis and repeatability
Response time	< 2 ms
Fluid temperature	-15 … +125 °C
Ambient temperature	-30 … +85 °C
Temperature incidence	±0.2%F.S./10K
Temperature incidence	Test conditions: At 25 °C
Output signal	4 … 20 mA
Power supply	7 … 33 V DC, 2-wire loop
Protected against short circuit and reverse polarity
Isolation voltage	500 V DC
Electric protection	Classe III
Connections	Connector DIN; EN 175301-803-A
Connections	Cable Ø 6 … 8 mm
Protection	IP 65 (connector DIN mounted)
Materials:
Body and fitting	AISI 316 L (1.4404)
Seal	FPM
Sensor	Piezo-resistive with ceramic diaphragm Al?O? (96 %)
Connector	Polyamide 50 % GF UL 94 V-0
Mounting:
Fitting	Male threads: G ¼” or G ½”
Mounting position	Vertical, connector upward (recommended)
Mass	90 g
Agreements
Electromagnetic compatibility	Directive EN 61326-2-3
EMC additional	Directive EN 50121-3-2
Mechanical Tests & Environmental Tests	Procedures IEC 68-2-27 & IEC 68-2-29
Vibrations, mechanical tests	Procedures IEC 68-2-6