Description Fuel Flow Meter Eurosens Difference-T is an analog-digital converter. It is used as a part of Fuel flow meter Eurosens Difference onboard weighing system: Receives information from a sensor with an analog output. Stores information about sensor calibration . Each sensor (analog input) can have up to 3 independent calibration tables. Converts the sensor’s […]
Eurosens DPS converts the air pressure in the output voltage or digital messages via serial RS485 or automotive CAN bus J1939 protocol. As the pressure transducer thin-film bridge is used. Eurosens DPS A output: Pressure, Mpa Output voltage, V 0 0,25 0,1 0,70 0,2 1,20 0,3 1,55 0,4 2,00 0,5 2,50 0,6 2,95 0,7 3,30 […]
Mechatronics Eurosens Difference onboard weighing system Remote axle load control and cargo weight calculation are highly demanded features of the GPS tracking systems. We developed Eurosens Difference onboard weighing system which provide features: Individual axle load measurement for truck and trailer. Cargo load calculation. Axle overload alarm. Show axle load and cargo weight at the […]
Mechatonics Eurosens DDS A(RS,CAN) axle load sensor Eurosens DDS converts the angle of rotation of the sensor’s lever to output signal. As the transducer is used magnetoresistive sensor.At the output of the sensor is formed stabilized analog voltage signal, which corresponds to the angular position of the pivot arm, changing depending on the load on […]
Eurosens Display CAN Flow indicator Interfaces CAN (SAE J1939), K-Line Interfacing to fuel flow meters, level sensors, MODBUS and LLS devices, analog and frequency sensors MODBUS and K-line output protocol Axle load information Sensor calibration table support Eurosens internal K-line bus networking MODBUS RS458 output interface Power voltage, V 10 – 60 Reverse polarity protection […]
Overview Eurosens Difference-T4 is an 4-channel analog-digital converter. It is used in advanced GPS tracking systems when extra analog inputs are needed: Receives information from a sensor with an analog output. Stores information about sensor calibration . Each sensor (analog input) can have up to 3 independent calibration tables. Converts the sensor’s signal to a […]