Bamo MNR 6 Magnetic Level Controllers has a Trigger point distances are determined prior to manufacture in relation to the sealing surface, in order to ensure the correct position of the contacts. The float can be removed from the bottom of the MNR6 controller (end stop ring removed). it is useful to order the option 2” coupler or a flange NB 50 to allow the float introduction from the tank top when possible.
Bamo MNR 6 Features
- Versions: PVC, PPH, PVDF or AISI 316
- 1 or 2 changeover contacts
- Reduced dimensions
- No effects of foam and vapours
- Measuring height: Up to 1500 mm
The use of a relay ES2001 is recommended to protect the Reed contact by a low intensity current in the loop and to procure a great longevity to the device.
Pumps and solenoid valves automation, low and high alarm signals, overfill detection, etc. The MNR 6 series is recommended for non-viscous, non-sticky liquids and without magnetic particles or suspended solids.
Bamo MNR 6 Specification
|Trigger point distances||From sealing surface: Min. 250 mm, Max. 1500 mm|
|Temperature limits||PVC-U: 5 … +50 °C; PPH: -5 … +80 °C|
|PVDF: -10 … +110 °C; AISI 316 L: -20 … +110|
|Pressure limits||°C Max. 3 bar at 20 °C for plastic versions|
|Max. 20 bar at 20 °C for stainless steel version|
|Stem and fitting||PVC, PP, PVDF or AISI 316 L|
|Float||PP, PVDF or AISI 316 L|
|Head housing||PBT for plastic versions; IP 65 (or DIN Plug IP 65)|
|Aluminum alloy for AISI 316L version; IP 54 (or DIN plug IP 65)|
|Number of contacts||1 or 2 changeover contacts|
|Terminals||Terminal board head housing or DIN Plug or cable output (3 m)|
|Gap between two contacts||Min. 100 mm|
|Accuracy||± 2 mm|
Download Data Sheet: Magnetic Level Controllers MNR 6
You must be logged in to post a comment.